- المشاركات
- 695
- مستوى التفاعل
- 101
- النقاط
- 28
How to Find Your Default Gateway
حل مشكلة الجهاز لا يستقبل الانترنت ** Configuring the IPv4 Default Gateway
حل مشكلة Djaweb ZXV10 W300 لا يستقبل الانترنت ** Configuring the IPv4 Default Gateway
If you are using a Windows-based computer, you simply need to access a Command Prompt to find out what the Default Gateway is. To access a Command Prompt, click on the “Start” menu button and search for “CMD”. Click to open.
If you are having a difficult time locating the Command Prompt using the start menu you can press the “Windows Key” on your keyboard while also pressing the “R” key. This will bring up the Run Menu. Now you can simply type “CMD” and click “OK”.
After opening the Command Prompt you should see a small black window like the one below.
In the Command Prompt window, type “ipconfig” and press “Enter/Return” on your keyboard. You will see a lot of information generated in this window. If you scroll up you should see “Default Gateway” with the device’s IP address listed to the right of it.
Configuring the IPv4 Default Gateway
Go to Control Panel > System > Network > IPv4 > Default Gateway.
Under Use the settings from, select an interface that QES will use as the default route.
Add a static route.
Click Static Route.
The Static Route window opens.
Specify an IP or subnet address.
Select an interface.
Click Apply.
QES adds the IP address and interface to the routing table.
Close the Static Route window.
Click Apply.
حل مشكلة الجهاز لا يستقبل الانترنت ** Configuring the IPv4 Default Gateway
حل مشكلة Djaweb ZXV10 W300 لا يستقبل الانترنت ** Configuring the IPv4 Default Gateway
If you are using a Windows-based computer, you simply need to access a Command Prompt to find out what the Default Gateway is. To access a Command Prompt, click on the “Start” menu button and search for “CMD”. Click to open.
If you are having a difficult time locating the Command Prompt using the start menu you can press the “Windows Key” on your keyboard while also pressing the “R” key. This will bring up the Run Menu. Now you can simply type “CMD” and click “OK”.
After opening the Command Prompt you should see a small black window like the one below.
In the Command Prompt window, type “ipconfig” and press “Enter/Return” on your keyboard. You will see a lot of information generated in this window. If you scroll up you should see “Default Gateway” with the device’s IP address listed to the right of it.
Configuring the IPv4 Default Gateway
Go to Control Panel > System > Network > IPv4 > Default Gateway.
Under Use the settings from, select an interface that QES will use as the default route.
Add a static route.
Click Static Route.
The Static Route window opens.
Specify an IP or subnet address.
Select an interface.
Click Apply.
QES adds the IP address and interface to the routing table.
Close the Static Route window.
Click Apply.
التعديل الأخير بواسطة المشرف: